Netis P116GH
With 16 FE POE ports, 2 Gigabit Up-link ports, and 1 SFP fiber port, the Netis P116GH is an 18-port standard POE switch. Power over Ethernet devices can be utilized with ports 1 through 16 since they have POE power supply capabilities. The IEEE 802.3af/at-compliant powered device may be immediately detected and recognized by the power supply port, which can then deliver power via the network connection. For NVR or up-link routers, 2 Gigabit uplink ports enable a seamless transfer. The most affordable option for an HD security network is P116GH.
Features of Netis P116GH
Supporting IEEE 802.3af/at compliant Powered Device (PD) and IEEE 802.3, 802.u Faster Ethernet, and 802.3ab 1000BASE-T.
- Modes: Standard switch mode and Extended mode (Ports 1 through 16: 250 meter long transmission
- Ports 1–16 characteristics Power over Ethernet (POE) power supply capabilities and usestwo 10/100/1000Base-T uplink and one 1000Base-X SFP Ethernet devices
- Support both half-duplex based on Backpressure and full-duplex based on IEEE802.3x
- All ports have automatic MDI/MDIX crossover.
- Support wire speed forwarding without blockage
- Auto-learning MAC address and auto-aging
- Steel casing, with a 240W total POE power budget
- Plug and play only
Product Specification
Hardware |
|
Interface | 16*10/100Mbps POE ports(Data/Power)
2*10/100/1000M uplink RJ45 ports (Data) 1*10/100/1000M uplink SFP slot port (Data) |
 Basic function
|
 Follow IEEE 802.3 Ethernet and IEEE802.3u Fast Ethernet Protocol
 Supports POE IEEE 802. 3af/at compliant Powered Device (PD)
Store-and-forward switching scheme |
 Standards
|
 IEEE 802.3 10BASE-T Ethernet
 IEEE 802.3i 10BASE-T Ethernet
IEEE 802.3u 100BASE-TX Fast Ethernet |
 Mode
|
 Normal switch mode/Extend mode
|
 Data Transfer Rate
|
Etherent:10Mbps(Half-duplex);20Mbps(Full-duplex)
Fast Entherent:100Mbps(Half-duplex);200Mbps(Full-duplex) |
 Store & Forwarding
|
Yes |
 Switching Capacity
|
9.2G |
 MAC Address
 Table Size
|
8K |
 Jumbo Frame
|
 2048 byte
|
 Environment
|
 Operation Temperature:0℃~40℃
 Storage Temperature:-40℃~70℃
 Operation Humidity:10%~90% RH Non-condensing
 Storage Humidity:5%~90% RH Non-condensing
|
 Power Input POE
 Standards
|
 Single port maximum power 30W,
Whole switch maximum power 240W Support over-current,over-voltage and short-circuit protection Support Soft Start of High Power PD  Support sequential boot-up
 Power Supply Pin:12+/36-
 AC 110~240V 50/60HZ
|
 Cabling type
|
 100Base-TX: Cat 5e or better UTP/STP(≤100m)
 10Base-TX: Cat 5e or better UTP/STP(≤250m)
|
Dimensions
(L x W x H )
|
 280mm*180mm*43mm
|
Reviews
There are no reviews yet.